Posted by Witch Doctor on September 20, 1999 at 03:50:19:
In Reply to: white spacer posted by richard ristaneo on September 19, 1999 at 21:02:17:
Best leave it be if you don't know a lot about
carbs. But if you insist on taking it out, pull
off the carb, remove the carb top, pull out the
slide, look on it or in carb body, remove two
screws, throw away spacer, reinstall metal piece.
Reassemble in reverse order...
Did I confuse you enough yet? Hope so. This mod
is really not for a novice. It isn't all that
hard to perform, but it sure is fun trying to
get a mikuni slider carb apart. The screws tend
to freeze up not long after the carb is made.
Mine tore up trying to do this.
Just open up your air screw(not easy to access).
Won't help much, but neither does the other.